Coala Supertack White High Gloss Ultra Permanent PVC Film 1524mm x 50 Metres 96 Micron

Printing

INSTALLATION
General
Coala Supertack owes its very high bond to the softness of the adhesive. The trade off for high tack and adhesion is greater than normal shrinkage. When decorating Coala Supertack with digital printing the solvent involved will penetrate both the vinyl and adhesive at the time of printing. If the printing solvents aren’t completely removed before installation the resultant graphic will show very high shrinkage and edge curl.
When printing this product be vigilant about drying the finished decal completely before laminating, top coating or installing.
Concrete, Masonry and Tile
The surface should be entirely dust free: high pressure TSP/water wash is the easiest method. The surface must be sealed with a complete coat of paint or concrete sealer and allowed to dry. If the surface is not sealed there must be no loose paint, grit or chalk present.
Sealing porous surfaces creates three benefits:
• Moisture cannot wick to the adhesive surface from within the matrix of the wall.
• Dust, due to ablation, cannot develop under the vinyl.
• Removal steps are much easier as the adhesive will remove more cleanly, and if any adhesive remains, the surface will be cleaned of residue more easily.
The surface temperature must be above 50°F. To assure highest adhesion the graphics will benefit from a final installation pass using a soft roller and heat source in combination. The film should be heated to a point of softening. Wait until the vinyl becomes “tack-free” and then roll the film tightly into the texture of the wall.
Although the film will stick well to horizontal walkways, etc. Antalis recommends using an approved “floor graphic” clear overlaminate atop any application of this kind.
Horizontal applications do not share the general warranties.
Plastic
These surfaces benefit from slightly roughening with sand paper before installation or surface oxidation with flame. For many polyolefinic surfaces, once the oily skin of the plastic is modified bond will improve dramatically. REMOVAL Addition of heat during removal will make the process much cleaner and faster. Where possible allow the surface to reach 27°C or more before removing the film.
Where ambient temperature is not that high use either a very “soft” flame type torch or heat gun to bring the temperature up. Antalis recommends getting the film and under laying adhesive above 38°C.
Remove the film in a continuous smooth motion at a shallow angle for the fastest separation. Where it is practical, two people on the removal make the job go far faster than using just one. With one person working the heating unit in front of the second person who is peeling film, the job proceeds at a uniform and consistent pace. Where only one person is working there will be constant starting and stopping in addition to the problems of the heat being very inconsistent.
SPECIAL CONSIDERATIONS
Because of the porous nature of all masonry and its general roughness Antalis does expect water, snow or ice to seep between the film and wall and collect on the upper edges of the applied graphic. For this reason applications to very rough surfaces do not carry the standard warranties.

Technical datasheet

• TS_EN_COALA_SUPERTACK_00_ISS_18072019.pdf